Engine Mount BRACKET SET: : 58-64 V8 around each door from about

around each door from about 1955 to the later 60's the edge was trimed with a foam or rubber filled windlace

not novice stuff

Option for USA made (normally USA made) MOOG brand or good aftermarket Tie Rods

These dampers can be used for the street

Engine Mount BRACKET SET: : 58-64 V8 around each door from aboutThis is the V8 Engine mount BRACKET set .. LH & RH. Your engine mount slips over this & the bolt goes thought it. Bracket head size is 2 5 8" not the smaller 2 3 8".. most 58 64's used 2. 5 8" Sold in pairs only This is whats also needed if changing from a 58 59 6cyl factory in line 6 to the chevy small block.. otherwise the tilt of the SBC will cause a rumble in the tail shaft drive line thats annoying.